What Is the Best Heat Pump for a Manufactured Home?

Neither wins outright. A package unit keeps everything outside on a pad and suits small closets and homes that already had a package unit. A split system keeps the blower and coil inside conditioned space and suits homes with an existing closet installation. The lot, the closet, the duct connection and the electrical service decide it, which is a decision made on site.

Downflow means the air handler pushes conditioned air out the bottom of the cabinet into a plenum in the floor, which feeds the metal trunk running under the home. Nearly all manufactured homes are ducted this way. Equipment that is not built for downflow either cannot connect to the plenum properly or cannot be installed in the closet at all.

Have a load calculation done on the home as it stands today, not as it was built. Additions, replaced windows, new skirting and duct condition all change the number. The data plate and comfort cooling certificate give a starting point, but they describe the original structure. A web page cannot size a system, and a like-for-like swap from the old tag often repeats an old mistake.

In the Phoenix climate, usually yes. Electric strip heat is the most expensive way to make heat, and a heat pump moves heat instead of generating it, which costs far less to run on a cold morning. The cooling side is the same either way. Whether the changeout makes sense now depends on the age and condition of what you have, which the repair-vs-replace guide can help you think through.

Intertherm, Miller, Nordyne and Nortek, Coleman, Revolv and Style Crest are the labels built around this market, with Goodman and Rheem-family equipment also found in these applications. We service and install as an independent contractor with no dealer or factory status for any of them. Specific model families beyond those names are research pending.

Only if the equipment was the cause. In manufactured homes, uneven cooling is more often a failed crossover duct, a torn belly board, or a crushed section of floor trunk. Replacing the heat pump without checking the ducts moves the same air through the same leaks. See manufactured home duct repair for what to look for.

Most Valley cities require a mechanical permit for a heat pump changeout, and many communities have their own rules about pad placement, skirting cuts and unit height. We handle the permit and can tell you what your park will likely ask for. Requirements vary by jurisdiction, so we confirm them on the estimate visit rather than promising in advance.